Domestic (CROSS 5)

Geared motor for frequent duty and built in control board

• The CROSS 5E is a rugged and powerful motor and has been designed to move gates up to 400-450kg and a maximin length of 20m 
• Easily accessible, built in electronic control panel
• New and special mechanical stop/limit switch brackets for perfect adjustment and to prevent accidental switch disengagement
• Easy key lock manual release system
• Power - 240 volt
• Adjustable opening speed can open at 0.16 or 0.25m/s - which makes this one of the fastest domestic/light commercial motors on the market
• Internal provisions for safety beams (for automatic close)

• The CROSS 5EH has the same characteristics as the Cross 5E with the following additonal features
• Power - Self protected low voltage motor 24 volt
• Battery back-up in the event of power failure

Domestic/Commercial (CROSS 7EH & 8E)

The Cross 7EH & 8E have the same basic features as the Cross 5 above but is ideal for heavy service in commercial or industrial entrances

• The CROSS 7EH  is designed to move gates up to 600kg
• Power - Self protected low voltage motor 24 volt
• Integrated electronic panel with easy-access on-board radio
• ABS modern-design casing
• New and special mechanical stop/limit switch brackets for perfect adjustment and to prevent accidental switch disengagement

• The CROSS 8E is designed to move gates up to 800kg
• Power - 240 volt
• This motor is also used in a domestic application if there is a moderate incline or decline in the travel of the gate

Heavy Commercial (CROSS 18VEK)

Ideal for high volume usage

• The CROSS 18VEK is designed to move gates up to 1800kg
• Power - 240 volt
• Incorporated control panel with broad range of functions
• Wide range of accessories to meet various operational requirements
• Outer casing in weather-resistant ABS
• 3 different end-of-stroke solutions

Click here to download Brochure

 Industrial

Industrial grade 3 phase inverter control drive motors to handle any intensive application (only single phase input required)

• The Industrial motors can move gates from 400kg-2000kg and can reach opening speeds of 630mm/sec
• Smooth, fully adjustable ramp up, ramp down, opening and closing speed for the ultimate in a gate drive operating control system
• Powerful microprocessor control board to provide various features required byt he operator
• Option of inverter/PLC combination with inbuilt model
• 100% duty cycle
• Inbuilt easy set limit switches